Pinouts >  Cars, Bikes and Trucks Diagnostic Link Connectors (DLC)
9 pin D-SUB male connector layout
9 pin D-SUB male connector
Pin Pin
Name
Description
1 Reserved Upgrade Path
2 CAN_L Dominant Low
3 CAN_GND Ground
4 Reserved Upgrade Path
5 CAN_SHLD Shield, Optional
6 GND Ground, Optional
7 CAN_H Dominant High
8 Reserved Upgrade Path
9 CAN_V+ Power, Optional

Controller Area Network (CAN) is a broadcast, differential serial bus standard, originally developed in the 1980s by Robert Bosch GmbH, for connecting electronic control units (ECUs). CAN was specifically designed to be robust in electromagnetically noisy environments and can utilize a differential balanced line like RS-485. It can be even more robust against noise if twisted pair wire is used. Although initially created for automotive purposes (as a vehicle bus), nowadays it is used in many embedded control applications (e.g., industrial) that may be subject to noise.

Bit rates up to 1 Mbit/s are possible at network lengths below 40 m. Decreasing the bit rate allows longer network distances (e.g. 125 kbit/s at 500 m).

The CAN data link layer protocol is standardized in ISO 11898-1 (2003). This standard describes mainly the data link layer, composed of the Logical Link Control (LLC) sublayer and the Media Access Control (MAC) sublayer and some aspects of the physical layer of the OSI Reference Model. All the other protocol layers are left to the network designer's choice.

According to 4 reports in our database (4 positive and 0 negative) the SAE J1939, CAN-CIA standard interface pinout should be correct.

Is this pinout
SAE J1939, CAN-CIA standard interface visual pinout:click to enlarge
Source(s) of this and additional information: www.interfacebus.com, wikipedia.org
Copyright © 2000-2023 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings