Bookmark /  Discuss  /  Edit  this page or submit new.
12 pin Ericsson cell phone proprietary connector layout
12 pin Ericsson cell phone proprietary connector
at the cellular phone
full pinout
Pin Description Comments
1 Audio Out  
2 Audio In  
3 Accessory Sense. GND to enable External Mic and Speaker (Analog)  
4 Audio Signal GND  
5 Portable handsfree In. Internal/external mic and ear (0=External - open=Internal)
6 Music Mute Out, High when phone is used.  
7 In Flash Memory Voltage and Service Voltage,
In 0V=normal,+5V=test, +12V=test+flash		 Test. Switch phone off and provide +5V and switch back on. (set comms at 115200, n,8,1)
8 Logic Out, Status On. Sources over 100mA. +3.3V output
9 TX (Data Out) from Mobile Station. Debug messages appear here at 112KBaud when in debug mode. TTL
10 Digital Ground and DC return  
11 Rx (Data in) TTL
12 DC in for battery charging, DC out for accessory power + external power supply 7.2Volt - 600mA
 
Is this document correct or incorrect?.
There are 3 reports in our database: 1 positive and 1 negative.
Pinouts.ru > A-N (Alcatel, ..., NEC) cell phones connectors pinouts > Pinout of Ericsson T10S, T18S, A1018S, 628, 688, 788 cell phones cable connector and layout of 12 pin Ericsson cell phone special connector
This page contain parts under Copyright © 2000-2011 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to Pinouts.ru . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.