APC BackUPS dumb cable (on-battery only) pinout

connector or cable wiring

9 pin D-SUB female connector
at the computer

This cable can only be used on voltage-signalling UPSes, and apparently only provides the On Battery signal. As a consequence, this cable is pretty much useless, because all APC UPSes support more than just On Battery.

     
     Signal Computer                  UPS
            DB9F                     DB9M
      DCD    1   --------------------  2  On Battery
     
                   3.3K ohm
      TxD    3   --[####]-*
                          |
      DTR    4   ---------*
      GND    5   ---------------*----  4  Ground
                                |
                                *----  9  Common

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

Want to add or correct something here? Edit this page!

9 pin D-SUB male connector
at the UPS

Pinouts.ru > GPS, UPS, Switches and other devices cables and adapters schematics > Pinout of APC BackUPS dumb cable (on-battery only) and layout of 9 pin D-SUB female connector and 9 pin D-SUB male connector	Is it correct?:	unknown
Source(s) of this and additional information: www.apcupsd.com	no reports
Last updated 2008-06-28 21:56:54. Edit this page.	Is this document correct or incorrect? What is your opinion?

[Discuss at the forum] [Back to index] [SUBMIT new pinout]

This page contain parts under Copyright © 2000-2008 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
6460 hits since January 11, 2008