Bookmark /  Обсудить  /  Редактировать  this page or добавить новую.
40 pin IDC female схематический вид разъема
40 pin IDC female разъем
at the Controller
40 pin IDC female схематический вид разъема
40 pin IDC female разъем
at the Drive 1 & Drive 2

The IDE interface requires only one cable. All pins straight from 1 to 1, 2 to 2 and so on. The drives can be connected in any order. Only remember that one should be jumpered as Master and the other as Slave. If only one drive is used, jumper it as Single (if such a mode exists, or most common Master else).

Controller         Drive 1 or 2   Drive 1 or 2
+--+                   +--+            +--+
|::|===================|::|============|::|  <-Pin 1
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
+--+                   +--+            +--+
Controller Drive 1 Drive 2
Wire 1-401-401-401-40
Этот документ правильный или с ошибками?.
There are 7 reports in our database: 7 positive and 0 negative.
Pinouts.ru > Кабели для дисководов > Распиновка IDE cable использующего разъем 40 pin IDC female и разъем 40 pin IDC female
This page contain parts under Copyright © 2000-2011 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to Pinouts.ru . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.