|
Pin Number |
Pin Name |
Description (may be empty) |
| 1 | ? | |
| 2 | ? | |
| 3 | Gnd | 0V |
| 4 | +5V | Supply via resistor |
| 5 | Rx | Data to PLC rs232 TTL |
| 6 | Tx | From PLC to PC TTL 232 |
Because I can't find good picture of socket, you need to rotate your PLC counter-clockwise - then numbers of pins will be OK.
Rx pin is pull-up'ed to +5V
For conecting to PC you need simply converter on MAX-232, only rx,tx are used.
After powering up PLC, Rx pin is Low about 3 seconds (lcd of plc is blank) , after that - is pull-up'ed.
Model easy 619 from moeller, works (comunicate) with free Allen Bradley PicoSoft :)
правильный
с ошибками