Navigon 7100, 7110, 5100, 5110 chargers pinout

GPS connector or cable wiring scheme

Pin	Pin Name	Description
1	+5V	5 Volts Direct Current
2	Data	floating/Not connected
3	Data	floating/Not connected
X	Ident	Conneted to Pin 4 (GND) as pure short, no resistor
4	Ground	Ground, shorted to pin "X"

Use of standard mini-b will place unit in Data Exchange/Synchronization mode. Use of mini-b with a 4-x pure short will allow use of Navigation software and concurrent charging. USB power source must be 1000 ma or above.

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

Want to add or correct something here? Edit this page!

Pinouts.ru > GPS receivers connectors pinouts listing > Pinout of Navigon 7100, 7110, 5100, 5110 chargers and layout of 5 pin mini-USB plug connector	Is it correct?:	should be correct
Contributor: Aero	1 reports
Last updated 2008-06-28 21:56:54. Edit this page.	Is this document correct or incorrect? What is your opinion?

[Discuss at the forum] [Back to index] [SUBMIT new pinout]

This page contain parts under Copyright © 2000-2008 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
8508 hits since November 13, 2007