Hardware pinouts information and cables schemes

SCSI Internal (Single-ended) pinout

hard drive connector

bookmark this page
50 pin IDC male connector layout
50 pin IDC male connector
at the controller & harddisk

SCSI=Small Computer System Interface. Based on an original design by Shugart Associates. SCSI was ratified in 1986.

Pin Name Dir Description
2DB0<->Data Bus 0
4DB1<->Data Bus 1
6DB2<->Data Bus 2
8DB3<->Data Bus 3
10DB4<->Data Bus 4
12DB5<->Data Bus 5
14DB6<->Data Bus 6
16DB7<->Data Bus 7
18PARITY<->Data Parity (odd Parity)
20GND---Ground
22GND---Ground
24GND---Ground
26TMPWR<->Termination Power
28GND---Ground
30GND---Ground
32/ATN<--Attention
34GND---Ground
36/BSY<->Busy
38/ACK<--Acknowledge
40/RST<->Reset
42/MSG-->Message
44/SEL<->Select
46/C/D-->Control/Data
48/REQ-->Request
50/I/O-->Input/Output
Note: Direction is Device relative Bus (other Devices).
All odd-numbered pins, except pin 25, are connected to ground. Pin 25 is left open.

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

Want to add or correct something here? Edit this page!
50 pin IDC female connector layout
50 pin IDC female connector
at the cable
Pinouts.ru > Hard drives connectors pinouts listing > Pinout of SCSI Internal (Single-ended) and layout of 50 pin IDC male connector and 50 pin IDC female connector
Is it correct?:
should be correct
Source(s) of this and additional information: Hardware Book
 1 reports
Last updated 2008-06-28 21:56:54. Edit this page. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2008 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
19679 hits since March 4, 2005