Pinouts >  Разъемы гарнитур и наушников и т.д.  >  Apple pinouts
4 pin 3.5mm (2.5mm) plug connector layout
Разъем 4 pin 3.5mm (2.5mm) plug
at the iPhone (2.5mm or 3.5mm, depends on model)
iPhone headphone (handsfree)
Для этой распиновки есть 36 совместимых устройств. Показать>
Pin
Number		 Pin
Name		 Description
1 Tip Left audio
2 Ring Right audio
3 Ring Common/Ground
4 Sleeve  Microphone

Pressing the headset button shorts Microphone to Ground

Inserting a 3-pin plug into the iPhone's 4-pin receptacle would also short Mic to Common and the L/R earphones will work correctly.

Using 4-pin Headsets provided by certain Phone Carriers also work with the microphone connection and certain remote functions.

Using iPod Earphone that use a microphone with a Cell phone may not provide the mic connection, and wil likely use the phone's internal mic instead.

The iPhone requires a certain impedance on the microphone pin for the input to be detected and used.  1600ohms is a good choice as it is very close to the mic on the standard Apple headphones.  So, if you are running an output from a PC or other amplified device into the iPhone mic input you will need to put a 1.6kohm resistor in series for it to work.  Tested on iPhone 3GS.

Статус распиновки: +23 -7
На распиновку iPod Nano (4th, 5th Gen), iPhone (1st, 2nd, 3rd, 4th Gen), iPod Shuffle (3rd Gen), Cell Phone Connection есть 33 отзыв(а): 23 положительных и 7 отрицательных.

Эта распиновка
Нет DIY устройств
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings