Bookmark /  Обсудить  /  Редактировать  this page or добавить новую.
x pins UNKNOWN схематический вид разъема
x pins UNKNOWN разъем
20 Pin Front panel USB, Speaker (Optional MIC) Proprietary
2..................20
1..................19
Viewed from the top (connector) side of the motherboard. 
Motherboard Pin
Name
Motherboard Pin
Number
Direction Pin
Number
Pin
Name
Description
Data0- 1 -?-     Data - for USB port 0 (Bottom)
Data0+ 3 -?-     Data + for USB port 0 (Bottom)
Data1- 5 -?-     Data - for USB port 1 (top)
Data1+ 7 -?-     Data + for USB port 1 (top)
GND 9 -?-     Ground
GND 11 -?-     Ground
Left Audio In * 13 -?-     Input for rear Audio (L) *
Right Audio In * 15 -?-     Input for rear Audio (R) *
GND 17 -?-     Ground
MIC IN 19 -?-     Microphone Input (+)
Detect ** 2 -?-     See below **
Vcc 4 -?-     +5V for USB ~Both~
? 6 -?-     Unknown
Vcc 8 -?-     +5V for USB ~Both~
Ring * 10 -?-     Speaker Ring & RS Terminal *
Tip * 12 -?-     Speaker Tip & TS Terminal *
Detect ** 14 -?-     See below **
Keyed 16 -?-     No pin
GND 18 -?-     Ground
? 20 -?-     Unknown

   To use this board in a non-dell case w/o front USB & sound:

*  Jump (connect) pins 10-13 (L) and 12-15 (R) for rear sound.

** Jump (connect) pins 2-14 to avoid "Front panel USB cable not detected" error.

The Dell Dimension 2400 uses the "standard" 9 pin USB header for the front ports and use a separate connector for the front headphone jack (the same connector used on many dells of that era).

Этот документ правильный или с ошибками?.
There are 4 reports in our database: 2 positive and 0 negative.
Pinouts.ru > Разные коннекторы на материнской плате > Распиновка Dell Dimension 2350, 2400 internal USB & Speaker использующего разъем
This page contain parts under Copyright © 2000-2011 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to Pinouts.ru . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.