Pinouts >  Распиновки разных разъемов на материнской плате  >  HP pinouts
16 pin IDC male connector layout
Разъем 16 pin IDC male
at the motherboard
Secondary COM port cable for the Hewlett Packard dc7900 series workstations.

 

Device 1
Pin Number		 Device 1
Pin Name		 Direction Device 2
Pin Number		 Device 2
Pin Name		 Description
1 DTR -> 4 DTR   
2 RX <- 2 RX   
3  CTS <- 8 CTS   
4   DSR <- 6 DSR   
5   TX -> 3 TX   
6   RI <- 9 RI   
7   GND   5 GND   
8   GND   5 GND   
9   +5.0V   NC No connect   
10   +3.3V_AUX   NC No connect   
11   RTS -> 7 RTS   
12   Comm B Detect   5 Pull this pin to GND  Must be connected to GND at boot time to enable 2nd the serial port.
13   DCD <- 1 DCD   
14   -12V   NC No connect   
15   +12V   NC No connect   

 

9 pin D-SUB male connector layout
Разъем 9 pin D-SUB male
at the bracket
Статус распиновки: +1 -0
На распиновку HP dc7900 secondary COM port header cable есть 1 отзыв(а): 1 положительных и 0 отрицательных.

Эта распиновка
Нет DIY устройств
Источник(и) этой и дополнительной информации: http://pinouts.ru/SerialPorts/Serial9_pinout.shtml; http://www.hp.com/ctg/Manual/c01549447.pdf
Copyright © 2000-2023 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.