Pinouts >  Распиновки для локальных компьютерных сетей
8 pin RJ45 (8P8C) male connector layout
Разъем 8 pin RJ45 (8P8C) male
Cisco / Juniper / Zyxel / Ubiquiti network devices with RJ45 console ports

Network devices with RJ45 console ports typically follow the Cisco pin out. The pinout below shows a null modem wiring between the RJ45 and the DB9 female connector. This is known to work on Cisco, Juniper, Zyxel and Ubiquiti Edge series devices with RJ45 console ports. If you are using UTP network cable then colour coding

 

RJ45 Pin
Number
RJ45 Pin
Name
DB9 Pin Number DB9 Pin Name Description

TIA/EIA
568A

TIA/EIA
568B
1 RTS

8

CTS Request To Send -> Clear To Send Orange/White Green/White
2 DTR 6 DSR Data Terminal Ready -> Data Set Ready Orange Grn
3 TXD 2 RXD Transmit Data -> Receive Data Green/White Orange/White
4 GND 5 GND Ground Blue Blue
5 GND 5   (tie pins 4/5 on RJ45 to Pin 5 on DB9 Blue/White Blue/White
6 RXD 3 TXD Receive Data <- Transmit Data Green Orange
7 DSR 4 DTR Data Set Ready -> Data Terminal Ready Brown/White Brown/White
8 CTS 7 RTS Clear To Send <- Request to Send Brown Brown
    9 RI Ring Indicator (not used)    

A simplified version of this NULL modem cable would only connect RXD, TXD and GND (this sacrifices flow control for simplicity). For other variations on null modem cables see this page

RJ45 Pin
Number
RJ45 Pin
Name
DB9 Pin Number DB9 Pin Name Description

TIA/EIA
568A

TIA/EIA
568B
3 TXD 2 RXD Transmit Data -> Receive Data Green/White Orange/White
5 GND 5 GND Ground Blue/White Blue/White
6 RXD 3 TXD Receive Data <- Transmit Data Green Orange
9 pin D-SUB female connector layout
Разъем 9 pin D-SUB female
На эту распиновку нет ни одного отзыва! Если вы знаете, правильная она или нет, - нажмите на соответствующую кнопку ниже.

Эта распиновка
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings