Bookmark /  Discuss  /  Edit  this page or submit new.
8 pin RJ45 (8P8C) male connector layout
8 pin RJ45 (8P8C) male connector
at the network interface card 1
8 pin RJ45 (8P8C) male connector layout
8 pin RJ45 (8P8C) male connector
at the network interface card 2
This cable can be used to connect two computers together without a hub, or to connect two hubs together (without using an uplink port). If you?re connecting two hubs together and one of them has an uplink port, use a straight cable.
Name Pin Pin Name
TX_D1+ 1 3 RX_D2+
TX_D1- 2 6 RX_D2-
RX_D2+ 3 1 TX_D1+
RX_D2- 6 2 TX_D1-
BI_D3+ 4 7 BI_D4+
BI_D3- 5 8 BI_D4-
BI_D4+ 7 4 BI_D3+
BI_D4- 8 5 BI_D3-

There are 2 types of cross-cables:
 

Note 1: It´s important that each pair is kept as a pair. TX+ & TX- must be in the pair, and RX+ & RX- must together in another pair etc. (Just as the table above shows).
Is this document correct or incorrect?.
There are 24 reports in our database: 22 positive and 2 negative.
Pinouts.ru > Network cables schematic pinouts listing > Pinout of Ethernet 100Base-T4 crossover cable and layout of 8 pin RJ45 (8P8C) male connector and 8 pin RJ45 (8P8C) male connector
This page contain parts under Copyright © 2000-2011 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to Pinouts.ru . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.