Hardware pinouts information and cables schemes

Ethernet 10Base-T crossover cable pinout

network cable scheme

bookmark this page
8 pin RJ45 (8P8C) male connector layout
8 pin RJ45 (8P8C) male connector
at the network interface card 1

This cable can be used to cascade hubs, or for connecting two Ethernet stations back-to-back without a hub. It works with both 10Base-T and 100Base-TX

Name NIC1 NIC2 Name
TX+13RX+
TX-26RX-
RX+31TX+
RX-62TX-
Note 1: It´s important that each pair is kept as a pair. TX+ & TX- must be in the pair, and RX+ & RX- must together in another pair. (Just as the table above shows). Note 2: You could also connect 4-4, 5-5, 7-7, 8-8.

Want to add or correct something here? Edit this page!
8 pin RJ45 (8P8C) male connector layout
8 pin RJ45 (8P8C) male connector
at the network interface card 2
Pinouts.ru > Network cables schematic pinouts listing > Pinout of Ethernet 10Base-T crossover cable and layout of 8 pin RJ45 (8P8C) male connector and 8 pin RJ45 (8P8C) male connector
Is it correct?:
should be correct
Source(s) of this and additional information: Hardware Book, Jason D. Pero , Oscar Fernandez Sierra, Jeffrey R. Broido, Patrick Smart
 7 reports
Last updated 2008-06-28 21:56:54. Edit this page. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2008 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
34186 hits since March 4, 2005