Hardware pinouts information and cables schemes

C64 Centronics Printer cable pinout

cable wiring

bookmark this page
24 pin DZM 12 DREH connector layout
24 pin DZM 12 DREH connector
at the C64 UserPort

Requires a cartridge with Centronics support (TFCIII or ActionReplay.)

  C64 Dir Printer  
GND 1,12,A,N --- 19-30,33 Ground
FLAG2 B <-- 10 Acknowledge
PB0 C --> 2 Data 0
PB1 D --> 3 Data 1
PB2 E --> 4 Data 2
PB3 F --> 5 Data 3
PB4 H --> 6 Data 4
PB5 J --> 7 Data 5
PB6 K --> 8 Data 6
PB7 L --> 9 Data 7
PA2 M --> 1 Strobe
/Reset 3 --> 31 Initialize Printer
 

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

Want to add or correct something here? Edit this page!
36 pin CENTRONICS male connector layout
36 pin CENTRONICS male connector
at the Printer
Pinouts.ru > Parallel interfaces and ports cables schemes > Pinout of C64 Centronics Printer cable and layout of connector and 36 pin CENTRONICS male connector
Is it correct?:
should be correct
Source(s) of this and additional information: CBM Memorial Page Pinouts, pinout by Roy Kannady, from Hardware Book, http://www.hardwarebook.info/C64/128_User_Port
Contributor: , Friderik Back
 1 reports
Last updated 2010-03-10 22:46:46. Edit this page. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2008 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
13816 hits since March 4, 2005