The Palm Serial Connector used before 2000/2001.

Pin Signal Description
1 DTR non-standart implementation of DTR. As long as the transceiver is enabled this pin outputs an asserted signal. 3.0 volts when transceiver shutdown (normal mode), 6.0 volts when transceiver enabled (Hotsync)
2 Vbat, +3.3v normally connected to HotSync (pin 7) with button
3 RxD GPS T
4 RTS  
5 TxD GPS R
6 CTS  
7 HotSync IRQ link to 3.3v (pin 2) for HotSync. Interrupt line for waking up device (initiate HotSync process in PalmOS).
8 ID Palm modem connect this pin to 3.3v (pin 2) by 20Kohm link
9 N/C* DC In in Palm III (+5VDC)
10 GND GPS -

*Palm V does not contain an internal charging circuit.

Maximum transmission rate is 115200 bps (57600 bps for modem).


 


 

Here is Palm Serial cable scheme


 


 


 

10 pin PALM proprietary of Palm Pilot, Palm III, V, VII, VIIx, Handera cable connector connector layout
10 pin PALM proprietary connector
9 pin D-SUB female connector layout
9 pin D-SUB female connector
According to 6 reports in our database (5 positive and 0 negative) this pinout should be correct.

Is this pinout
Palm Pilot, Palm III, V, VII, VIIx, Handera cable connector visual pinout:
Palm Pilot, Palm III, V, VII, VIIx, Handera cable connector diagram
click to enlarge
Source(s) of this and additional information: kolumbus.fi
This page contain parts under Copyright © 2000-2015 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to Pinouts.ru . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.