Hardware pinouts information and cables schemes

Cisco Console port (at Catalyst 5000 Series Switch) pinout

serial interface

bookmark this page

The Cisco Consule port is used on the Cisco Catalyst 5000 Series Switch Supervisor Engine III

Console Port Console device
Pin+SignalConnect to
1looped to 8 
2(DTR)DSR
3(RxD)TxD
4(GND)GND
5(GND)GND
6(TxD)RxD
7(DSR)DTR
8looped to 1 

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

Want to add or correct something here? Edit this page!
Pinouts.ru > RS-232 and other serial ports and interfaces pinouts listing > Pinout of Cisco Console port (at Catalyst 5000 Series Switch) and layout of 8 pin RJ45 (8P8C) female connector and 8 pin RJ45 (8P8C) male connector
Is it correct?:
unknown
Source(s) of this and additional information: comp.sys.cbm General FAQ v3.1 Part 7, from Hardware Book
no reports
Last updated 2008-06-28 21:56:54. Edit this page. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2008 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
22507 hits since March 4, 2005