Pinouts >  UPS devices  >  APC pinouts
9 pin D-SUB male connector layout
9 pin D-SUB male connector
at the PC
APC part # 940-0119A.
The pinout should fit 2 devices/models. Click to list>

Compaible with:

  • Back-UPS Office (serial)    BF350, BF500

The BackUPS ES has a straight through serial cable with no identification on the plugs.

     computer           ----------- BackUPS-ES -----------------
     DB9-M              DB-9F
     pin    signal      pin
     
      4      DSR   ->    4 --+
                             |  diode   resistor
      6      DTR   ->    6 --+---->|----///---o kill power
     
      1      DCD   <-    1 --+
                             |
      2      RxD   <-    2 --+----------------+--o low battery
                                              |
      7      RTS   ->    7 --------+--///--+
                                   |
                                   +--///--+
                                              |
      8      RI    <-    8 --+----------------+--o on battery
                             |
      9      CTS   <-    9 --+
     
      5      GND   ---   5 ----------------------o ground
     
      3      TxD         3 nc
 
Pinout status: +0 -0
There are no any reports for this pinout! You may rate this document by clicking the button below.

Is this pinout
NO DIY devices
Source(s) of this and additional information: www.apcupsd.com
Copyright © 2000-2023 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings