UPS devices  > Fiskars pinouts
Pin # Signal Type Function
1 Basic Modem Mode;
Input: RS232 high pulse 4 to 5 seconds wide 
Remote UPS off: In presence of  AC, Output will turn off for 15 seconds after conditionaldelay. In absence of AC, output is kept off until normal AC returns 
1 Serial Data Mode;
Input: RS232 data 
RS232 serial communication input. 1200 baud, 8-bit, no parity, one stop bit, one start bit, Xon/Xoff 
2 Basic Mode;
Output: RS232 level high 
AC Input failure 
2 Serial Data Mode;
Output: RS232 data
RS232 serial communication output. Same as input
3 Output: Open collector transistor ON, 50 mA. 40 VDC rating AC Input failure
4 Signal Common Signal Common
5 Output: Open collector transistor ON. SO mA. 40 VDC rating  Impending low battery
6 Input: RS232 level low (-12V) Plug and Play software enable trigger
7 Input: Relay contact or RS232 level  Remote output OFF/ON: UPS total output can be kept off with low signal or closing relay contact 
8 Output: 8 to 25 VDC, 5 W constant power (0.63 A max. @ 8V) Auxiliary Control Power
9 Chassis  Connection to chassis
9 pin D-SUB male connector layout
9 pin D-SUB male connector
at the UPS
According to 1 reports in our database (1 positive and 0 negative) this pinout should be correct.

Is this pinout
Fiskars PowerRite UPS port visual pinout:
Fiskars PowerRite UPS port diagram
click to enlarge
Source(s) of this and additional information: UPS FAQ in russian
This page contain parts under Copyright © 2000-2015 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to Pinouts.ru . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.