8 pin RJ45 male connector diagram and applications

8 pin RJ45 male used in:

• Cisco Console port (at Catalyst 5000 Series Switch) The Cisco Consule port is used on the Cisco Catalyst 5000 Series Switch Supervisor Engine III
• Ethernet 100Base-T4 100Base-T4 uses all four pairs. 100Base-TX only uses two pairs
• Cisco Auxiliary port for Cisco 1000, 1600, 2500, 2600, and 3600 series routers The auxiliary port is configured as data terminal equipment (DTE)
• Cisco console port for Cisco 1000, 1600, 2500, 2600, And 3600 series routers The console and auxiliary ports on Cisco IOS routers are asynchronous serial ports. The console port is configured as data communications equipment (DCE)
• RS-232D 
• Cisco Asynchronous-Line RJ45 to 68Pin SCSI cable 
• Ethernet 1000Base-T (Gigabit ethernet) 1000 Base-T uses all pairs for bidirectional traffic in the RJ45 connector. cables used should be of Category 5e(nhanced), even though Category 5 cables usually works too.
• Cisco RJ45 to DB25 adapter 
• Ethernet 10Base-T crossover cable This cable can be used to cascade hubs, or for connecting two Ethernet stations back-to-back without a hub. It works with both 10Base-T and 100Base-TX
• Ethernet 100Base-T4 crossover cable This cable can be used to connect two computers together without a hub, or to connect two hubs together (without using an uplink port). If you´re connecting two hubs together and one of them has an uplink port, use a straight cable.
• Cisco RJ45 RollOver cable 
• Phase I PC modem cable 
• Phase II PC modem cable 
• Phase I Macintosh modem cable 
• Phase II Macintosh modem cable 
• RocketPort Serial (25) cable Use this cable to connect a RocketPort serialport card to a modem.
• Allied Telesyn/Network iQ1000 router serial port cable serial port for configuring router
• Ethernet 1Gb crossover cable 1Gb ethernet is autosensing, so crossover usually not needed
• ADC Pairgain 310F and 320F console used to connect PC to ADSL modem console
• Adtran CSUs RJ45 to DB9 cable 
• Ethernet 10 / 100 Mbit (cat 5) network cable wiring This is most common cable for 10/100Base-T ethernet networks. This cable will work with both 10Base-T (10 Mbit ethernet) and 100Base-TX (100 Mbit ethernet) and is used to connect a network interface card to a hub or network outlet. These cables are sometimes called wipes.
• ISDN BRI RJ45 
• Ethernet 10/100Base-T ( rj-45) connector Widely used in ethernet network devices. Same connector and pinout for both 10Base-T and 100Base-TX.
• Cyclades cabling diagrams 
• Unibox, Griffin, Multi-Box, Nokia Flasher, UFS, Tornado GSM universal boxes devices for flashing cellular phones
• Power other Ethernet (POE) Power over Ethernet is a technology that allows IP telephones, wireless LAN Access Points, Security network cameras and other IP-based terminals to receive power, in parallel to data, over the existing CAT-5 Ethernet infrastructure without the need to make any modifications in it. Described by IEEE 802.3af standard.
• LS 2208 Scaner to PS/2 connector adapter for connecting barcode scanner to ps/2 interface
• Yaesu Vertex Microphone for yaesu & vertex radios
• RocketPort Serialport Available at RocketPort serialport expansion cards.
  
  
  Associated connector:
  
  
  8 pin RJ45 female used in:
  
• Cisco Console port (at Catalyst 5000 Series Switch) The Cisco Consule port is used on the Cisco Catalyst 5000 Series Switch Supervisor Engine III
• Cisco Console (25) cable Use this cable to configure a Cisco router thru the Console port at the router.
• Cisco Console (9) cable Use this cable to configure a Cisco router thru the Console port at the router.
• Ethernet 100Base-T4 100Base-T4 uses all four pairs. 100Base-TX only uses two pairs
• Cisco Auxiliary port for Cisco 1000, 1600, 2500, 2600, and 3600 series routers The auxiliary port is configured as data terminal equipment (DTE)
• Cisco console port for Cisco 1000, 1600, 2500, 2600, And 3600 series routers The console and auxiliary ports on Cisco IOS routers are asynchronous serial ports. The console port is configured as data communications equipment (DCE)
• RS-232D 
• Ethernet 1000Base-T (Gigabit ethernet) 1000 Base-T uses all pairs for bidirectional traffic in the RJ45 connector. cables used should be of Category 5e(nhanced), even though Category 5 cables usually works too.
• Token Ring RJ-45 Alternate Connection to DB-9 Token Ring
• Avocent / Cybex / BlackBox XPSI and KV1609C serial control cards RJ45 connector of the 4XP / XP4000 / XP4040 / ServSwitch Multi EXP
• ISDN BRI RJ45 
• Ethernet 10/100Base-T ( rj-45) connector Widely used in ethernet network devices. Same connector and pinout for both 10Base-T and 100Base-TX.
• GSM all-in-one (Unibox) cable 
• Unibox, Griffin, Multi-Box, Nokia Flasher, UFS, Tornado GSM universal boxes devices for flashing cellular phones
• Power other Ethernet (POE) Power over Ethernet is a technology that allows IP telephones, wireless LAN Access Points, Security network cameras and other IP-based terminals to receive power, in parallel to data, over the existing CAT-5 Ethernet infrastructure without the need to make any modifications in it. Described by IEEE 802.3af standard.
• Motorola Radius Mic conector for SM50-GM300-p1225
• RocketPort Serialport Available at RocketPort serialport expansion cards.