« previous next »
Pages: [1] |   Go Down

Author Topic: palm_treo650 comments  (Read 14250 times)

anonymous

  • Guest
palm_treo650 comments
« on: August 03, 2007, 03:55:25 »
Be careful when using this pinout and accompanying image.  If you are referring to any of the Palm documentation on the multiconnector, be advised that as of the 3rd of August 2006 all the Palm documents number the pins in the opposite direction.
Logged

admin

  • Administrator
  • *****
  • Posts: 96
Re: palm_treo650 comments
« Reply #1 on: August 06, 2007, 21:17:16 »
Updated.
Thank you!
Logged

ISABELLE

  • Junior Member
  • *
  • Posts: 1
Re: palm_treo650 comments
« Reply #2 on: December 16, 2008, 13:44:23 »
I need to buy the Multiconnector ( 18 positions) or also called " Athena connector", used in palms ( Tungstene E2 for instance).
Do you know where I could buy it from or who is the manufacturer for these connectors ????
Thx for your help !
Logged
Pages: [1] |   Go Up
« previous next »
 

+ Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Name: Email:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image
Type the letters shown in the picture:
5x8=: