« previous next »
Pages: [1] |   Go Down

Author Topic: Connect PS/2 to RJ11.  (Read 8165 times)

mking

  • Junior Member
  • *
  • Posts: 1
Connect PS/2 to RJ11.
« on: September 11, 2005, 01:21:13 »
Hello,

how can I make from a 6-pin mini-din MALE connector through a 6-pin FEMALE mini-din connector a RJ11 MALE connector?

I've got the Haicom 204S GPS receiver which has a 6-pin mini-din connector. But I have got a TOMTOM car-kit for Dell Axim X3/X3i which requires a RJ11 FEMALE.

Now I want to make a cable which I can put on the mini-din MALE connector (So a mini-din FEMALE) of the GPS and on the other side of the same cable I want to have a RJ11 FEMALE connector.

Is this possible to make?
Can I buy it somewhere on the net?
Or could I build one myself?

I don't really know the answer on these questions, so please help me out.

Best regards,

mking
Logged
Pages: [1] |   Go Up
« previous next »
 

+ Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Name: Email:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image
Type the letters shown in the picture:
5x8=: