« previous next »
Pages: [1] |   Go Down

Author Topic: HP server PSU pinout  (Read 994 times)

toonttm

  • Junior Member
  • *
  • Posts: 1
HP server PSU pinout
« on: July 16, 2011, 08:44:10 »
Hi,

I have just got a HP server PSU that I want to run as a PSU to a charger for large RC batteries.
I am trying to find out what connectors I need wire permantely to turn the PSU on.

I can get around 11V output by linking pins 2 and 5 together. I haven't tried a load resistor yet to see if this will work but the power LED doesn't come on.

HP HSTNS-PL11
generic part: 490594-001

Pics attached of connector board and label on outside of case.
(can't attach pics? The connectors are 6 small strips then 2 large strips. One of the large strips is earth and I assume the other is +ve output.

Thanks

« Last Edit: July 16, 2011, 08:48:14 by toonttm »
Logged
Pages: [1] |   Go Up
« previous next »
 

+ Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Name: Email:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image
Type the letters shown in the picture:
5x8=: