Connectors not respecting the undo function

Started by ricardobrooks, Aug 08, 2018, 12:34

previous topic - next topic
| Go Down

ricardobrooks

Hi,

In a new draw file, draw four boxes, one at each corner of the page.Draw a connector between the box in the upper-left corner and the box in the upper-right corner.Drag the right end of the connector down to the box on the bottom-right of the screen (so the connector now runs from the top-left box to the bottom-right box).Edit->Undo (so the connector now runs from the top-left to the top-right boxes again)Drag the left end of the connector down to the box on the bottom-left of the screen (so the connector SHOULD now run from bottom-left box to the top-right box).Observe how the connector jumps and is now running from the bottom-left box to the bottom-right box.Anyone else having this problem? Does it still exist in 4.0?

Please help.

I didn't find the right solution from the Internet.

References:-
https://forum.openoffice.org/en/forum/viewtopic.php?f=11&t=64628#p286897
Utility Management Example

Thanks!

| Go Up