Network cables schematic pinouts listing

• Ethernet 10 / 100 Mbit (cat 5) network cable wiring This is most common cable for 10/100Base-T ethernet networks. This cable will work with both 10Base-T (10 Mbit ethernet) and 100Base-TX (100 Mbit ethernet) and is used to connect a network interface card to a hub or network outlet. These cables are sometimes called wipes.
• Ethernet 100Base-T4 crossover cable This cable can be used to connect two computers together without a hub, or to connect two hubs together (without using an uplink port). If you´re connecting two hubs together and one of them has an uplink port, use a straight cable.
• Ethernet 10Base-T crossover cable This cable can be used to cascade hubs, or for connecting two Ethernet stations back-to-back without a hub. It works with both 10Base-T and 100Base-TX
• Ethernet 1Gb crossover cable 1Gb ethernet is autosensing, so crossover usually not needed

• Cisco RJ45 RollOver cable 

• AAUI to AUI cable 
• Ethernet AUI to AUI cable This cable can be used to connect to network interface cards (with AUI connector) together, without use of transcievers