Point Of Sale Devices: scanners, printers, cash registers cables and connectors
Used on the DYMO/CoStar LabelWriter thermal printers that connect through RS-232.
LabelWriter Pin
LabelWriter Pin
Direction computer Pin
computer Pin
CTS 1 --> 8 CTS Clear to send
TXD 2 <-- 3 TXD RS232 Transmit (to LabelWriter)
RXD 3 --> 2 RXD RS232 Receive (from LabelWriter)
GND 4 --- 5 GND Ground
RTS 5 <-- 7 RTS Request to send
DSR 6 --> 6 DSR Data set ready

This pinout comes from the cable that came with a CoStar LabelWriter XL Plus, tested with a multimeter. (It is likely that its the same one used for other LabelWriters made by CoStar and DYMO, but this is merely speculation.)


6 pin RJ12 (6P6C) male connector layout
6 pin RJ12 (6P6C) male connector
at the LabelWriter
9 pin D-SUB female connector layout
9 pin D-SUB female connector
at the computer
According to 3 reports in our database (3 positive and 0 negative) this pinout should be correct.

Is this pinout
CoStar/DYMO LabelWriter RS-232 Cable visual pinout:
CoStar/DYMO LabelWriter RS-232 Cable diagram
click to enlarge
This page contain parts under Copyright © 2000-2018 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to Pinouts.ru . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.