Pinouts >  Распиновки последовательных портов
The Model 745 was a late-70s dumb terminal with built-in acoustic coupler, with an external connection for direct computer or external modem use.

Keyboard/Printer EIA Interface

Description Cable Termination (DB-25P)
1 SIG GND Signal Ground 7
9 PRO GND Protective Ground 1
10 +12V +12 Volts to RTS (EIA on +3V when power is on) 4
11 DCD Data Carrier Detect (Held to EIA ON by external equipment) 8
12 RXD Receive Data 3
13 TXD

Transmit Data

15 DTR Data Terminal Ready (DTR is +3V when terminal is online) 20

(Relative to the keyboard and printer)

Acoustic Coupler Interface:

Pin Number

Pin Name Description

Cable Termination

1 SIG GND Signal Ground 7
2 DCD Carrier Detect 8
3 TXD Transmit Data 2
6 CTS Clear To Send 5
7 DSR Data Set Ready 6
8 RXD Receive Data 3
9 PRO GND Protective Ground 1

(Relative to the acoustic Coupler internal to the terminal and on another connector)


The Jumper connector (to use the internal Acoustic Coupler when configured for external use), is 3 connections:

From pin To Pin
2 11
3 13
8 12


15 pin D-SUB male схематический вид разъема
Разъем 15 pin D-SUB male
at the terminal
На эту распиновку нет ни одного отзыва! Если вы знаете, правильная она или нет, - нажмите на соответствующую кнопку ниже.

Эта распиновка
This page contain parts under Copyright © 2000-2019 by team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.