Oct 22, 2021, 12:59

Recent posts

Pages 1 ... 8 9 10
Interfaces, Pinouts, Cables / Re: add a new pinout
Last post by admin - May 24, 2017, 23:57
Thank you for your attention.
Interfaces, Pinouts, Cables / add a new pinout
Last post by hardgore - May 24, 2017, 19:12
hi :)
i want to add a new pinout here:
about this: "a connector in 2.1 computer speakers : altec lansing - atp3
when i click to add new pinout, it goes here:
http://connector.pinouts.ru/add.php?lang=eng    (page not found)

What is this connector? One end goes to the armrest of the car(Honda Accord 2002,Japanese) Img01 Img02
Interfaces, Pinouts, Cables / GPS Antenna 3.5mm jack pinout
Last post by trbn - May 24, 2017, 01:16
Anyone know the pinout output of the following products:




Народ. Помощи!
 Scart to S-Video http://pinouts.ru/VideoCables/scart_adapter.shtml . Припаял Luminance out и Chrominance out (S-Video) к 15,19 (Scart) Показывает.
Н о при контакте Chrominance return Luminance return (S-Video) с любым общим контактом 17,13,18,21 - изображение становится чёрно-белым. То же:  Chrominance return + 20 (S-Video).   Luminance return  + 20 (S-Video) - показывает.
Нужно ли обязательно припаивать землю?
Update the camera plug in is a 6-pin and the S video is of course a four pins but I do know which the wire is for power and grounds but what's the rest thanks
I had a security camera General Electric wired color camera with corroded s video plug in that needs to be replaced I can find nowhere what the pin configuration is so that I can use a replacement does anybody know what would be the standard plug in for a TV or for this the company that makes this is out of business and so I'm just trying to make it work any ideas I'd love to hear them
I'm attempting to start the Dell Dimension 3100 Motherboard by connecting the Power pin to a gnd pin, but nothing seems to work. I have checked the voltages, and that seems to check out. Anyone have any suggestions as to what pins I must connect to initialize the motherboard? ???
I know this is old, but thought I'd post an answer just in case.

I think I understand that you want to turn on the PSU to check the voltages, but are afraid of cooking it?

The PSU ON pin needs to be grounded to turn on the PSU.  This means that you should take a paper clip or other wire and connect the PSU ON pin to ground (plug an end into each of the PSU ON and GND pins) and then plug in the PSU to the mains power.

I'm sure you know that you can test all of the voltages by putting one multimeter probe on one pin and the other on a nearby ground pin (with the PSU on of course).

Hope that helps.
FА не подскажите распиновку СОМ порта на Dell Optiplex 390?
Pages 1 ... 8 9 10