hello my name is Daniel and i need cable adapter ide pc to ide notebook 2,5 thank you
Hy! As i know this is not an adapter, there is no any tricky, all pinouts are same functions, just smaller.
i suggest that, let's cut at middle an 2,5 cable and an normal IDE cable, and connect cables each by each.
but i need conected 12 volts in plug 40 pines
looking at the hard drive, where the key pin is on the bottom, go to the left side, power plugs in there. ground on top.
ascii just for kicks.
viewing from the hard drive's arse
1 22
::::::::::::.:::::::::
23 44
1 = GND
13 = KEY
23 = 12VDC+
sorry... sorry... ignore the one on top, i wrote it up backwards.
this is correct:
1 22
::::::::::::':::::::::
23 44
1 = GND
35 = KEY
23 = 12VDC+
melcy is completely wrong, do NOT use that pinout. the extra 4 pins on the end are two +5v, one ground, and one not connected. look up the individual pinouts. all toher pins are identical