Hi,
I have a question about AAUI.
I bought a wrong transceiver (AAUI) while I needed a AUI transceiver (to RJ45). :(
Can i simply cut the AAUI connector from the transceiver and attach a DB15 connector (AUI) like on : http://www.fortunecity.de/wolkenkratzer/486/60/aui_aaui.htm
I think I then have to connect following AAUI signals to the coresponding AUI signals :
RX+
RX-
TX+
TX-
CI+
CI-
GND
What do i have to do with the power signals ? 12V or 5V ?
Is it possible to use a AAUI transceiver to connect to a AUI host (network card) ?
I just found this link : http://pinouts.ru/NetworkCables/aaui2aui_pinout.shtml
It is the same connection as above, but it connects :
voltage plus pin1 (AAUI) to pin13 (AUI)
so it connects the +5V from the AAUI to the +12V AUI.
So my AUI device will provide +12V on the +5V connection of the AAUI transceiver, will this not damage the AAUI transceiver ?
Or does the 12V provide the necesscary +5V supply for the transceiver ?
Many thanks in advance,
Monty :D
don't know much about aaui and aui standards but if the supply level is the only thing you're worried about you could always add a voltage divider, a linear regulator, a zener diode, or a combination of the above. with a good sized heat sink, a linear regulator would probably give you the most stable supply. you'll be looking at a 7805 regulator for this application.