Recent posts

#11

Interfaces, Pinouts, Cables / Audi_2005-2008_Symphony

Last post by pttk - Mar 07, 2022, 18:35

Hi, I have recently replaced the Symphony 2 with the 2+, I used an RNS-E harness, but when I connected the radio it did not turn on, we had to connect a power point to the fuse box, this does not look good.
When turning on the radio does not turn on, you have to do it with the power button.
I think this can be corrected by properly using the harness pins.
Thanks for the help

https://pinoutguide.com/Car-Stereo-Audi/Audi_2005-2008_Symphony_I_pinout.shtml









Any idea?

#12

Обсуждение способов подключения, распиновок, сигналов / HP Proliant Pinouts для автоно...

Last post by Aanistratenko - Feb 25, 2022, 15:59

Всем привет.

Нам необходимо запустить блок питания автономно без сервера.
HSTNS-PL48 Power Supply for DL20 DL60 DL80 DL120 DL160 DL180

При подаче на вход 220В на выходе 0.

Поделитесь распиновкой разъемов.

Может у кого-то уже есть опыт?

#13

Interfaces, Pinouts, Cables / Computer fan tack signal (4 wi...

Last post by sid3 - Jan 24, 2022, 19:09

Hello,

Question: 
The documentation from this site states that the tach wire is pulled to ground for every revolution of the fan.  How long is it pulled to ground ?  the entire revolution until the next ?  x number of milliseconds ?
I don't have a setup right now were I can measure it.  But I wanted to know if someone had some documentation on what its supposed to be.

Any help is appreciated.
Thanks
Sid.

#14

Interfaces, Pinouts, Cables / Engine swap Pin out diagram

Last post by Hondo - Nov 12, 2021, 00:32

Doing an engine swap and trying to locate the pin layout for identifying which pin is what. Have the part number and V.I.N. for both vehicle. One is a 2011 Ford F250 and other is a 2017 Ford F450. Do not want to cut and solder but swap the plug if possible. If anyone knows where I could locate the layouts for both , it would be much appreciated.
Thank you in advance.

#15

Interfaces, Pinouts, Cables / Hard wire unit

Last post by jmv - Oct 28, 2021, 00:41

I want to hard wire this unit into my camper.  Does anyone have a diagram showing the pin nomenclature & color codes?

#16

Interfaces, Pinouts, Cables / No sound

Last post by Rob1944 - Sep 23, 2021, 14:31

Hi plugged in a after market sterio in 2004 Lexus rx300 sterio comes on fine but no sound any ideas please

Bob

#17

Обсуждение способов подключения, распиновок, сигналов / Re: Ищу распиновку кабеля для ...

Last post by admin - Sep 15, 2021, 18:18

Есть такая https://pinouts.ru/Electronics/ATEN_CS1644_Firmware_Upgr.shtml
Может подойдет.

#18

Обсуждение способов подключения, распиновок, сигналов / Ищу распиновку кабеля для прош...

Last post by vi767 - Sep 15, 2021, 16:38

Ищу распиновку кабеля для прошивки КВМ ATEN LIN5-04A2-J13G - стерео jack на com портYou cannot view this attachment.

#19

Interfaces, Pinouts, Cables / mPcie 2.0/3.0 x1 to nvme m2 ad...

Last post by Hem Pushp Mittal - Sep 13, 2021, 14:27

Hello There,

Anyone here is aware how to interface the mPCIe signals to M.2 adaptor for NVME SSD drives?

#20

Interfaces, Pinouts, Cables / 2014 Bluetooth handsfree cable...

Last post by CarmeloLabadie - Sep 04, 2021, 18:04

Anyone have a source for a 32 pin harness for connecting to the wiring that goes into the Bluetooth Handsfree unit? This is in a 2014 EX without navigation, with i-Mid.

I want to replace the factory radio without cutting into any of the existing wiring. The Axxess HDCC-01/ASWC-1 combo comes with a harness for all the other connectors, but not that one. I want to use the phone controls, and maybe the built in mic that are in that connector.