Cisco DB60 to DB60 Correction

Started by dangdanw, May 24, 2007, 19:42

Previous topic - Next topic

dangdanw

Remarks at the bottom of the Cisco DB60 to DB60 pinout page should read...

This was deduced from two X.21 cables hooked back to back. For DCE side I had to add 2 extra wires (Pins 25,26) not used in X.21, and swapped most pin pairs. I currently use this cable between a Cisco 2520 and a Cisco 1601 at 1.5 Mb/sec.
-------------

I am currently making a Cisco DB-60 to DB-60 cable using the pinouts of two V35 cables back to back. It should be good for 4 Mb/s.

Andrew