Hardware pinouts information and cables schemes

RS-232 serial cable specification users reports and reviews

[Discuss at the forum] [SUBMIT new pinout]

There are 14 approved reports in our database

Date Content
Revision
User opinion Comment Approved by moderator?
CORRECTAPPROVED
ERROR FIXEDRTS/CTS discussion sounds weird, and I believe it"s actually wrong. RTS is asserted when the DTE is ready to _SEND_ (not receive, as is stated), and the DCE responds by raising CTS if it is ready to receive. APPROVED
CORRECTEverything"s fineAPPROVED
CORRECTAPPROVED
CORRECTWorkingAPPROVED
CORRECTAPPROVED
2009-01-10 16:07:10rev. 2CORRECTAPPROVED
2009-08-22 00:51:25rev. 2CORRECTAPPROVED
2010-07-15 19:03:56rev. 2CORRECTAPPROVED
2013-02-12 21:58:38rev. 2CORRECTAPPROVED
2013-11-25 12:10:13rev. 2CORRECTnopeAPPROVED
2015-12-22 18:20:26rev. 9CORRECTAPPROVED
2016-03-22 18:07:17rev. 9ERROR FIXEDIt is graphicly correct, but it looks like you only swapped where it should be swapped but neglected to reflect the swap in your pin numbers. I was getting ready to solder according to the pin numbers and it shows pin 3 to pin 3,which would send the transmit wire of one computer into the transmit out of the other. Well let me know if i'm missing something.DanAPPROVED
2016-07-13 15:22:07rev. 9CORRECTAPPROVED


History of users contributions

Date Content
Revision
Author Comment

Back to RS-232 serial cable pinout


Pinouts.ru > Pinout of Null modem cables and layout of 9 pin D-SUB female connector and 25 pin D-SUB female connector
should be correct