Date | Content Revision |
User opinion | Comment | Approved by moderator? |
---|---|---|---|---|
INCORRECT | seems no work any of this diagrams,, i test with a t28 and t616 | APPROVED | ||
INCORRECT | APPROVED | |||
CORRECT | serial data cable sheme mark as correct but miss the autopower 232 explanation | APPROVED | ||
INCORRECT | APPROVED | |||
ERROR FIXED | First diagram is incorrect: the capacitor on pin 2 of MAX232 must be between pin2 and GND, not between pin2 and Vcc. | APPROVED | ||
CORRECT | APPROVED | |||
CORRECT | The "Another scheme for almost all of Ericsson and SonyEricsson cellular phones" works just fine for me! | APPROVED | ||
CORRECT | APPROVED | |||
CORRECT | The documento is 100% correct. I just made the flashing one and the data one and worked as espected. Thanks. | APPROVED | ||
CORRECT | APPROVED | |||
CORRECT | APPROVED | |||
INCORRECT | The values of C1-C4 are for Vcc between 3.0V to 3.6V. Readers should refer to, Table 2. Required Minimum Capacitor Values of the MAX3232 datasheet (www.maxim-ic.com) for Vcc between 4.5V to 5.5V. The datasheet also indicates C3 CAN BE RETURNED TO EITHER VCC OR GROUND, not just ground. | APPROVED | ||
CORRECT | Please put a direct link to http://pinouts.ru/CellularPhones-P-W/erics_t28_pinout.shtml in this page. | APPROVED | ||
CORRECT | APPROVED | |||
CORRECT | The schematics was very accurate!!!!!!! Thank you for your help.... | APPROVED | ||
CORRECT | The service cable ok. with SE K300i. MAX232N is work with 1uF capacitors. THX | APPROVED | ||
2015-01-10 17:33:07 | rev. 2 | CORRECT | APPROVED |
Date | Content Revision |
Author | Comment |
---|---|---|---|
2010-08-01 22:45:53 | rev. 2 |
Pinouts.ru > Pinout of Ericsson and some Sony Ericsson universal data and service cables schematic and layout of 9 pin D-SUB female connector and 11 pin Ericsson cell phone special connector |
should be correct |