Pinouts >  Интерфейсы цифровых видео и фотокамер  >  Canon pinouts
3 pin N3 Canon plug connector layout
Разъем 3 pin N3 Canon plug
with N3 connector. The connector may be obtained from wired remote control


3 GND Ground
2 FOCUS short to pin 3 to focus Canon camera
1 SHUTTER short to pin 3 to trigger shutter

If the camera is in stand-by mode, there is a 3.3V voltage present at the focus wire. The camera can be waken up from stand-by by connecting the focus wire to ground. The trigger inputs can serve as power supply for circuits with a supply current of less than 30µA.

На распиновку Canon EOS 10D, 20D, 30D, 40D, 50D, 5D, 5Dmk2, 7D manual shooter / focus connector есть 1 отзыв(а): 1 положительных и 0 отрицательных.

Эта распиновка
Источник(и) этой и дополнительной информации:
Copyright © 2000-2023 by team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.