Pinouts >  Интерфейсы цифровых видео и фотокамер  >  Dakota pinouts
10 pin PALM proprietary connector layout
Разъем 10 pin PALM proprietary
May be used to build your own USB cable and connect this camera to the comuter.

Pin 1 is closest to the shutter release button, and pin 10 is closest to the battery door at the bottom. The connector is the same type used on the older Palm Pilots e.g. Palm III, VIII Hotsync Cable (with some peeling).

Pin Signal Name Description
1
 

 
goes to R57 (unpopulated), to U2.79. Use unknown.
 
2
 
Ground
 
3
 

 
R18 (4.7K) - U2.30 (P31) & delete button. Also through R68 (unpopulated) to JP1.2
4
 

 
R2 (unpopulated) - pin 6 of SST program memory FLASH. This is address bit 17, which isnt used by the size FLASH memory installed.
 
5
 

 
R5 (1K) - U2.33 (P13). Use unknown.
 
6
 
USB +5V power
 
Connects to red wire.
 
7
 
USB Ground
 
Connects to black wire (you can also use pin 2 or 10).
 
8
 
USB Data +
 
Connects to green wire.
 
9
 
USB Data -
 
Connects to white wire.
 
10
 
Ground
 

 
На эту распиновку нет ни одного отзыва! Если вы знаете, правильная она или нет, - нажмите на соответствующую кнопку ниже.

Эта распиновка
Источник(и) этой и дополнительной информации: Disposable Digital Camera Interfacing, < a href="http://cexx.org/dakota/">cexx.org/dakota
Copyright © 2000-2023 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.