Pinouts >  Распиновки кабелей и переходников для клавиатур, мышей и т.д.  >  Belkin pinouts
9 pin D-SUB female connector layout
Разъем 9 pin D-SUB female
at the PC
Belkin DB9-to-RJ11 Serial Flash Cable schematic

This is a cable pinout for Belkin KVMs with RJ11 for Flashing ( OmniView Pro3: F1DA104Z, F1DA108Z or F1DA116Z - maybe others but this have to be verified).

 

DB-9
Pin Number		 DB-9
Pin Name		 Direction KVM RJ11
Pin Number		 KVM RJ11
Pin Name		 Description
2   RXD <-- 1 Tx Receiver 
3   TXD --> 2 Rx Transmitter 
5 GND  --- 4 GND Ground 
All other pins have to be left unconnected.

Tested with Belkin OmniView Pro3 8-port KVM ( F1DA108Z ) .

For firmware update instruction (for OmniView Pro3) look for document "Firmware Upgrade Instructions for Pro3 KVM Switches", to update, use dedicated application "Upgrade Utility 1.2" (or newer - should be available with the firmware for your OmniView).

4 pin RJ11 male connector layout
Разъем 4 pin RJ11 male
at the KVM
Статус распиновки: +2 -0
На распиновку Belkin DB9 to RJ11 Serial Flash Cable есть 2 отзыв(а): 2 положительных и 0 отрицательных.

Эта распиновка
Нет DIY устройств
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings