Pinouts >  Распиновки разных разъемов на материнской плате  >  HP pinouts
4 pin single row male connector layout
Разъем 4 pin single row male
Proprietary 4 pin CPU Fan connector

This is the CPU Fan Pinout for the Proliant ML310 Generation 1, may be compatible to other Proliant Servers and ML310 Generations.

Uses non-standard 4-Pin-Fan-Connector Wiring, possibly to lock out cheap 3rd party fans.

The only special line is the Status-Line. For normal operation, it is tied to Pin 1 (GND). An Open Pin 2 means either Fan not present or Fan Failure.


1 GND  
2 Status  Fan Present / Fan Failure
3 Sense  Standard Tachometry Signal
4 12 V  

Bridge Pin 1 and 2 to be able to connect normal Fans. Please bear in mind that in this connector Sense comes before 12V, not the other way around as in normal Fan connectors, so if you force a 3-pin Fan on this connector after bridging 1&2 at the Mainboard, swap Sense and 12V first!

In order to bypass the fan moniter on a Proliant ML330 G3 which has this exact same pin out.   connect pin 1 to pin 2 then place a 27 Ohm resisister between pins 2 and 3.  The server will see a CPU fan in perfect health.

На распиновку HP Compaq ProLiant ML310 G1 4-pin CPU Fan есть 3 отзыв(а): 3 положительных и 0 отрицательных.

Эта распиновка
Источник(и) этой и дополнительной информации: Own work through "reverse engineering" the board
Copyright © 2000-2023 by team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.