Pinouts >  Распиновки кабелей и разъемов оборудования торговой точки: сканнеров, принтеров, касс  >  Welch pinouts
15 pin D-SUB female connector layout
Разъем 15 pin D-SUB female
at the back of the 8300-4
for Scanteam 8300-4 check/MSR/barcode reader. Differs from 8300-1, 8300-2.
back of the 8300-4
Pin		 Name Direction Description
1 Logic Ground  
2 VCC (+5vdc) For supplying +5 VDC to the scanner
3 RXD Receive data (RS-232 voltages)
4 CTS Clear to Send (RS-232 voltages)
5 KbdDataIn Keyboard wedge data (from a keyboard)
6 KbdClkIn Keyboard wedge clock (from a keyboard)
7 RDATA -?- OCIA
8 Data ready -?- OCR, or 5B RX/TX
9 Vin(+12vdc) +12 VDC input, optional if +5 VDC is supplied
10 Bootstrap Short to ground to enable bootstrap mode
11 TXD Transmit data (RS-232 voltages)
12 RTS Request to Send (RS-232 voltages)
13 KbdDataOut Keyboard data (to computer)
14 KbdClkOut Keyboard clock (to computer)
15 5B RX2/TX2 -?- 5B RX/TX (inverted)
 
Статус распиновки: +0 -0
На эту распиновку нет ни одного отзыва! Если вы знаете, правильная она или нет, - нажмите на соответствующую кнопку ниже.

Эта распиновка
Нет DIY устройств
Источник(и) этой и дополнительной информации: Michael Graff
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings