Pinouts.ru talks

English => Interfaces, Pinouts, Cables => Topic started by: Frosty on Feb 19, 2009, 16:50

Title: 10 pin idc to rj12 sniffer cable
Post by: Frosty on Feb 19, 2009, 16:50
Hey all;

This is my first post but i was wondering if someone could help me.

What I have is a stepper motor which uses the 10 pin idc connector, this is connected to a plc on rs485 which uses the rj12 connector, I have been online to both using hyperterminal to see the data being sent in both directions but when its just the plc to stepper the plc is receiving data that I did not see on hyperterminal.

What I want to do is tap into this comms with a db9 connector so that I can see whats being sent in both directions on hyperterminal.

I don't want to buy a cable so what id need is the wiring diagram.

If anyone can help me or recommend where I could find such a wiring diagram i'd appreciate it.

Many thanks in advance;

Frosty