|
3.5 inch micro Floppy Disk Drive connector (26 pin) specification users reports and reviews |
| Date | Content Revision |
User opinion | Comment | Approved by moderator? |
|---|---|---|---|---|
| CORRECT | APPROVED | |||
| CORRECT | APPROVED | |||
| INCORRECT | Floppy disk connector is 34pin. | APPROVED | ||
| CORRECT | is correct, is for laptop floppys | APPROVED | ||
| 2009-04-15 21:33:37 | rev. 2 | CORRECT | CORRECT | APPROVED |
| 2009-04-25 13:42:53 | rev. 2 | CORRECT | CORRECT, it's notebook floppy connector | APPROVED |
| 2010-02-09 21:36:06 | rev. 2 | CORRECT | I have found this pinout used for the 3.5 floppy in the Toshiba T5200/100 (a 1989 era 386 portable). | APPROVED |
| 2012-10-09 16:40:50 | rev. 4 | ERROR FIXED | Pin8 (READY) and Pin9 (MEDIA) are used only from older drives. In newer drives they are not connected. | APPROVED |
| 2012-12-31 18:24:30 | rev. 4 | CORRECT | APPROVED | |
| 2017-12-21 14:50:23 | rev. 7 | ERROR FIXED | Not for Toshiba's Citizen 26 pins floppy drives! | APPROVED |
| 2018-09-07 18:25:18 | rev. 8 | CORRECT | APPROVED | |
| 2019-09-11 20:22:10 | rev. 8 | CORRECT | APPROVED | |
| 2020-08-05 20:55:26 | rev. 8 | CORRECT | APPROVED | |
| 2022-11-15 21:56:56 | rev. 8 | CORRECT | No, the pinout perfectly matches my laptop. Put 1K pullup resistors on pins 8 and 9, as my new drive does not provide signals for these and the laptop apparently needs them; works perfectly. | APPROVED |
| 2023-05-31 02:44:58 | rev. 8 | CORRECT | APPROVED | |
| 2023-09-09 19:56:53 | rev. 8 | CORRECT | APPROVED |
| Date | Content Revision |
Author | Comment |
|---|---|---|---|
| 2010-04-18 15:02:50 | rev. 3 | S. Brunsch | Be careful! The conductor side at the flexfoil connector can vary. |
| 2014-03-05 20:40:51 | rev. 5 | Info in top |
Pinouts.ru > Pinout of 3.5 inch micro Floppy Disk Drive connector (26 pin) and layout of connector |
should be correct |