|
Compaq Rack server power supply specification users reports and reviews |
| Date | Content Revision |
User opinion | Comment | Approved by moderator? |
|---|---|---|---|---|
| 2009-12-19 18:33:54 | rev. 2 | CORRECT | no errors to my knowledge,,what is REM,WR,PG and F/M. i want to know which pins to jump to turn on power supply while it is out of the unit. | APPROVED |
| 2010-03-09 03:44:56 | rev. 2 | ERROR FIXED | the pin out image is upside down. if you leave the numbers where they are, flip only the connector vertically. (i.e. pin 1 and 12 should be U-shaped, not square) | APPROVED |
| 2012-07-24 19:37:11 | rev. 5 | INCORRECT | My PSU doesn't turn on when I pull 23 and 24 to GND! | APPROVED |
| 2014-12-16 17:57:29 | rev. 5 | CORRECT | seem to be right | APPROVED |
| 2017-01-15 14:17:21 | rev. 5 | CORRECT | Распиновка верная. Помогло, когда потребовалось прикрутить обычный ATX блок к старичку compaq dl320 Единственное нужно отметить, 12-й пин должен быть заземлен, это фан менеджер, иначе будет стопориться на биосе с ошибкой по фану. | APPROVED |
| 2017-09-27 04:59:10 | rev. 5 | CORRECT | APPROVED | |
| 2023-08-12 16:35:44 | rev. 5 | CORRECT | No errors, I tested all pins and all are correct. | APPROVED |
| Date | Content Revision |
Author | Comment |
|---|---|---|---|
| 2010-09-25 22:40:14 | rev. 3 | Andre Gro?e Bley | I got a unit for repair on my lab table and sharing some results |
| 2011-08-18 13:11:35 | rev. 4 | Julius | pin 23 reads H8 or HB and needs to be GND also to power ON all the Voltages otherwise only the fans run low and +5V HS is there |
| 2011-11-24 22:26:01 | rev. 5 | previous version too long |
Pinouts.ru > Pinout of Compaq Rack server power supply |
should be correct |