|
Sony Ericsson R520, R310, R320, T28, T39, T68, T68i, T610, T630 and others cell phones cable connector specification users reports and reviews |
| Date | Content Revision |
User opinion | Comment | Approved by moderator? |
|---|---|---|---|---|
| CORRECT | APPROVED | |||
| CORRECT | Rabotaet primenial dlia terminator dongle | APPROVED | ||
| CORRECT | For T68i:For unlocking pin 6,7,9,10,11 (Do a bridge between 9 & 11) are OK | APPROVED | ||
| CORRECT | APPROVED | |||
| CORRECT | APPROVED | |||
| CORRECT | APPROVED | |||
| CORRECT | Looks like the same pinout on the Sony Ericsson V600i. Havent tested it (dont have equipment to test) | APPROVED | ||
| 2009-07-16 16:03:43 | rev. 4 | CORRECT | correct, but it's also correct for model J300i, because this model is compatible with K300i | APPROVED |
| 2009-09-15 12:48:12 | rev. 4 | CORRECT | I edited the page to emphasize something, that it is not shown in the tables of the pinouts. It is reported at the bottom of the page, but only for K300i model. Do something about it | APPROVED |
| 2010-04-06 16:33:26 | rev. 4 | CORRECT | APPROVED | |
| 2011-12-19 21:17:35 | rev. 4 | INCORRECT | From my point of view, pin 2 should be CTS (input signal to phone) and pin 3 should be RTS (output signal). I say this because I made an adapter using MAX232 for a T290 cellphone and the connection worked when I connect RTS from serial port to pin 2 at phone and CTS from serial port to pin 3 at phone (through MAX232: DB9-Pin7 to pin 13, pin 12 to Phone-Pin2, DB9-Pin8 to pin 14, pin 11 to Phone-Pin3). Can somebody else confirm this? RX and TX are fine. | APPROVED |
| 2012-01-11 18:16:58 | rev. 4 | CORRECT | APPROVED | |
| 2012-10-08 02:30:35 | rev. 4 | CORRECT | APPROVED | |
| 2012-10-26 19:19:01 | rev. 4 | INCORRECT | APPROVED | |
| 2013-02-04 17:28:46 | rev. 4 | CORRECT | APPROVED | |
| 2013-09-07 21:42:47 | rev. 4 | CORRECT | APPROVED | |
| 2023-01-16 18:42:47 | rev. 6 | CORRECT | No, works correctly | APPROVED |
| Date | Content Revision |
Author | Comment |
|---|---|---|---|
| 2009-01-03 22:34:17 | rev. 4 | Niranjan | The (Tx)&(Rx) are reverse for K300i model, you must connect CTS & DGND together on board and connect the common wire to CTS(Pin3) in phone connector. if your cable is working fine then dont change it. It works for me, try at your own risk. |
| 2009-10-22 23:36:10 | rev. 4 | Nikos Psarakis | |
| 2014-11-17 21:22:05 | rev. 5 | ppwo | more variants |
Pinouts.ru > Pinout of Sony Ericsson R520, R310, R320, T28, T39, T68, T68i, R600, T610, T310 and others cell phones cable connector and layout of 11 pin Ericsson cell phone special connector |
should be correct |