|
Ford OBD-II diagnostic interface specification users reports and reviews |
| Date | Content Revision |
User opinion | Comment | Approved by moderator? |
|---|---|---|---|---|
| 2010-11-27 05:12:42 | rev. 3 | ERROR FIXED | pins: 3, 11 used for low speed (125kb) CAN bus. This bus used for same IC, RFA and other units. pin3 - hi pin11 - lo | APPROVED |
| 2014-12-10 00:07:07 | rev. 5 | INCORRECT | On a 2000 expedition the CAN + is pin 10 and it doesn't pinpoint what Pin 13 is. | APPROVED |
| 2016-03-23 00:38:50 | rev. 5 | ERROR FIXED | I need the square obd or can connector for the 1996 Ford falcon Futura with actve Torque control | APPROVED |
| 2016-05-16 23:19:31 | rev. 6 | CORRECT | APPROVED | |
| 2016-09-21 22:14:25 | rev. 6 | INCORRECT | pin 14 should be can high | APPROVED |
| 2017-06-23 12:56:37 | rev. 7 | CORRECT | at ford new models have MS-CAN | APPROVED |
| 2017-09-29 02:34:44 | rev. 7 | CORRECT | looks to be what is in my Ford Ranger wiring diagrams | APPROVED |
| 2018-01-29 04:39:06 | rev. 7 | ERROR FIXED | my pin layout being used is 2,4,5,7,10,13,16. Vehicle is 1999 Ford Explorer Can not find info for pin 13. Thanks for the help. | APPROVED |
| 2018-06-13 23:34:51 | rev. 8 | CORRECT | APPROVED | |
| 2019-07-02 15:34:18 | rev. 8 | CORRECT | It would help to know the volt range required at each pin location | APPROVED |
| 2020-11-30 00:55:37 | rev. 8 | CORRECT | APPROVED | |
| 2021-04-20 17:13:34 | rev. 8 | CORRECT | The obd2 shuts down the gps unit when it reads the vin. is this a function of shuting down the engine? | APPROVED |
| 2024-07-07 11:42:54 | rev. 8 | CORRECT | Well, you could probably list the volts for pins like #7 #10 #16. With both key on & off | APPROVED |
| Date | Content Revision |
Author | Comment |
|---|
Pinouts.ru > Pinout of Ford OBD-II diagnostic interface |
should be correct |