|
Yaesu / Vertex VX and FT series Handheld Microphone / Speaker Mic specification users reports and reviews |
| Date | Content Revision |
User opinion | Comment | Approved by moderator? |
|---|---|---|---|---|
| 2010-10-08 03:57:10 | rev. 3 | INCORRECT | pinouts for speaker and mic are reversed on the vx-6r. I have no experience with other yaesu radios. | APPROVED |
| 2011-10-21 00:47:23 | rev. 4 | ERROR FIXED | pinouts for speaker and mic are reversed on the vx-3r. | APPROVED |
| 2015-05-02 22:01:33 | rev. 5 | INCORRECT | This item did not take me to a wiring Diagram as I was expecting it to. | APPROVED |
| 2015-05-06 16:51:06 | rev. 5 | CORRECT | No | APPROVED |
| 2015-10-24 10:04:04 | rev. 5 | CORRECT | APPROVED | |
| 2016-03-19 22:05:11 | rev. 5 | ERROR FIXED | You have pins 1 & 3 reversed. Pin 1 is speaker. | APPROVED |
| 2016-08-01 15:39:22 | rev. 6 | ERROR FIXED | there should be a 2.2k-ohm resistor between the mic and shield to activate the PTT | APPROVED |
| 2017-10-07 13:40:47 | rev. 7 | CORRECT | Correct ! | APPROVED |
| 2019-08-06 23:10:34 | rev. 7 | CORRECT | APPROVED | |
| 2019-12-15 11:48:35 | rev. 7 | CORRECT | Glad to have finally found one that works. | APPROVED |
| 2020-01-24 22:54:40 | rev. 7 | CORRECT | APPROVED | |
| 2020-05-05 08:09:07 | rev. 7 | CORRECT | This is correct. Both Tx and Rx are connected to clone. | APPROVED |
| 2021-02-09 20:51:00 | rev. 7 | CORRECT | APPROVED | |
| 2021-03-25 09:11:07 | rev. 7 | CORRECT | APPROVED | |
| 2021-09-12 06:34:26 | rev. 7 | ERROR FIXED | This pinout is not for the VX-8DR. The VX-8DR has a 7 pin connector for data, mic, speaker and PTT. | APPROVED |
| Date | Content Revision |
Author | Comment |
|---|---|---|---|
| 2010-07-25 21:39:14 | rev. 2 | KD5JBN |
Pinouts.ru > Pinout of Yaesu / Vertex VX and FT series Handheld Microphone / Speaker Mic |
should be correct |