Pinouts >  Различные устройства  >  TDS pinouts

неизвестный разъем
LTBHBTD84H10CK 5.7inch monochrome display (from TDS1000s series oscilloscope).

Pin
Number
Pin
Name
Description
1 FRM Frame strobing pin, goes high on first row (line) data
2 LOAD Data latching pin, goes low when writing each line data. Behaving more like a horizontal sync signal
3 CLK (or CP) Data clocking pin, Display data made available by MPU on rising edge, sample by display on falling edge 
4 DISP Display enable pin, Active high
5 VDD 5 VDC digital logic supply
6 GND Ground pin
7 VEE 24 VDC LCD bias voltage (Vary from 21 VDC to 24 VDC depends on display contrast setting)
8 D0 Bit 0 pixel data input
9 D1 Bit 1 pixel data input
10 D2 Bit 2 pixel data input
11 D3 Bit 3 pixel data input
12 GND Ground pin

The connector type is Molex Wire to board connector call Picoblade. This one has 12 pins and 1.25mm pin pitch.

There's chinese-made conpatible connector from  SHOU HAN that you can source from LCSC.

 

Extra useful information of this display :

The waveform diagram below was referenced from a similar Kyocera display module.

I confirmed this waveform format by probing the signal coming from the ASIC of the TDS1012 

На эту распиновку нет ни одного отзыва! Если вы знаете, правильная она или нет, - нажмите на соответствующую кнопку ниже.

Эта распиновка
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings