Pinouts >  Распиновки разъемов винчестеров других устройств хранения информации
The SFF-8484 connectors are commonly found on some older SAS/ SATA controllers, i.e. Dell PERC 5/i, PERC 6i. Nowdays SFF-8484 is mostly superseeded by SFF-8087.

The SFF-8484 (and newer SFF-8087) are used for internal four lane connections. 

Common cable configurations are SFF-8484 to 4x SFF-8482 (plus a four pin Molex connector) or SFF-8484 to four 7-pin SATA style connectors.

1   GND   
2   Rx0+   Lane 0
3  Rx0-    Lane 0
4   GND   
5   Tx0-   Lane 0
6   Tx0+   Lane 0
7   GND   
8   Rx1+   Lane 1
9   Rx1-   Lane 1
10   GND   
11   Tx1-   Lane 1
12   Tx1+   Lane 1
13   GND   
14   Sideband 0   
15   Sideband 1   
16   Sideband 2     
17   Sideband 3     
18   Sideband 4   
19   Sideband 5   
20   GND   
21   Rx2+   Lane 2
22   Rx2-   Lane 2
23   GND   
24   Tx2-   Lane 2
25   Tx2+   Lane 2
26   GND   
27   Rx3+   Lane 3
28   Rx3-   Lane 3
29   GND   
30   Tx3-   Lane 3
31   Tx3+   Lane 3
32   GND   

Some lanes may be not connected in cable (depends on cable and host configuration). I.E. in cable with 3 physical links lane 3 pins (27,28,30,31) will be N/C.

SFF-8484 are directional and are wired differently if used at the "host" (controller) end than if used at the "target" (drive or drive rack/cage) end. SFF-8484 at the target end is probably less common but it was used in Supermicro CSE-M14T and some Dell Precision 29xx series drive cages.

32 pin SAS internal SFF-8484 female схематический вид разъема
Разъем 32 pin SAS internal SFF-8484 female
at the cable
32 pin SAS internal SFF-8484 male edge схематический вид разъема
Разъем 32 pin SAS internal SFF-8484 male edge
at the backplane
На эту распиновку есть 1 отзыв(а): 0 положительных и 0 отрицательных.

Эта распиновка
Источник(и) этой и дополнительной информации: Serial Attached SCSI - 1.1 (SAS-1.1) draft
This page contain parts under Copyright © 2000-2019 by team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.