Pinouts >  Кабели для локальных сетей
8 pin RJ45 (8P8C) male connector layout
Разъем 8 pin RJ45 (8P8C) male
at the network interface card 1
This cable can be used to connect two computers together without a hub, or to connect two hubs together (without using an uplink port). If you are connecting two hubs together and one of them has an uplink port, use a straight cable. Most hubs nowadays are autosensing.

The crossover cable differ from cable used for straightforward  Ethernet RJ45 connection. In order to make Crossover Ethernet cable wire one RJ-45 connector using the T-568A standard and the other RJ-45 connector using the T-568B standard.

Ethernet crossover cable pin assignment:

Name Pin Pin Name
TX_D1+ 1 3 RX_D2+
TX_D1- 2 6 RX_D2-
RX_D2+ 3 1 TX_D1+
RX_D2- 6 2 TX_D1-
BI_D3+ 4 7 BI_D4+
BI_D3- 5 8 BI_D4-
BI_D4+ 7 4 BI_D3+
BI_D4- 8 5 BI_D3-


 

Ethernet cat 5 Crossover Cable pinout and wiring scheme

Note 1: It´s important that each pair is kept as a pair. TX+ & TX- must be in the pair, and RX+ & RX- must together in another pair etc. (Just as the table above shows).

How to wire Ethernet UTP network cable

8 pin RJ45 (8P8C) male connector layout
Разъем 8 pin RJ45 (8P8C) male
at the network interface card 2
Статус распиновки: +23 -7
На распиновку Кросс кабель локальной сети Ethernet есть 32 отзыв(а): 23 положительных и 7 отрицательных.

Эта распиновка
1 сопутствующих распиновок
Нет DIY устройств
Источник(и) этой и дополнительной информации: Hardware Book, Kim Scholte
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings