Pinouts >  Схемы кабелей для последовательных портов
4 pin USB A receptacle connector layout
Разъем 4 pin USB A receptacle
Very simple. Maximum length of cable is about 5 m for AWG20 and 0.8 m for AWG28 cable.
Pin
one side
Signal Description Pin
other side
1 USB Vcc (Vbus) usually RED, wire should be 20-28 AWG 1
2 USB Data - usually WHITE, wire should be 28 AWG 2
3 USB Data + usually GREEN, wire should be 28 AWG 3
4 GND usually BLACK, wire should be 20-28 AWG 4

USB D+ and D- are twisted in cable. Outer shell is made of copper braid and aluminum shield. 

Colors do not mean anything in the wiring scheme. You can use any color wire to rig something. Just make sure the colors match from end to end. Using the de-facto color is for industry types only.

The maximum length of a standard USB cable (for USB 2.0 or earlier) is 5 metres with devices operating at full speed (12 Mbit/s) or high speed (480mbit/s), and a maximum length of 3 metres with devices operating at low speed (1.5 Mbit/s) The primary reason for this limit is the maximum allowed round-trip delay of about 1,500 ns. If USB host commands are unanswered by the USB device within the allowed time, the host considers the command lost. The USB 3.0 standard does not directly specify a maximum cable length, requiring only that all cables meet an electrical specification: for copper cabling with AWG 26 wires the maximum practical length is 3 meters.

The data cables for USB 1.x and USB 2.x use a twisted pair to reduce noise and crosstalk. USB 3.0 cables are more complex and employ shielding for some of the added data lines (2 pairs); a shield is added around the pair sketched.

4 pin USB A plug connector layout
Разъем 4 pin USB A plug
На распиновку USB 2.0 cable schematic есть 65 отзыв(а): 58 положительных и 5 отрицательных.

Эта распиновка
Источник(и) этой и дополнительной информации: wikipedia.org
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings