May 19, 2022, 22:35

Recent posts

Pages 1 2 3 4 ... 10
11
Interfaces, Pinouts, Cables / Audi_2005-2008_Symphony
Last post by pttk - Mar 07, 2022, 21:35
Hi, I have recently replaced the Symphony 2 with the 2+, I used an RNS-E harness, but when I connected the radio it did not turn on, we had to connect a power point to the fuse box, this does not look good.
When turning on the radio does not turn on, you have to do it with the power button.
I think this can be corrected by properly using the harness pins.
Thanks for the help

https://pinoutguide.com/Car-Stereo-Audi/Audi_2005-2008_Symphony_I_pinout.shtml









Any idea?
12
Всем привет.

Нам необходимо запустить блок питания автономно без сервера.
HSTNS-PL48 Power Supply for DL20 DL60 DL80 DL120 DL160 DL180

При подаче на вход 220В на выходе 0.

Поделитесь распиновкой разъемов.

Может у кого-то уже есть опыт?


13
Hello,

Question: 
The documentation from this site states that the tach wire is pulled to ground for every revolution of the fan.  How long is it pulled to ground ?  the entire revolution until the next ?  x number of milliseconds ?
I don't have a setup right now were I can measure it.  But I wanted to know if someone had some documentation on what its supposed to be.

Any help is appreciated.
Thanks
Sid.
14
Interfaces, Pinouts, Cables / Engine swap Pin out diagram
Last post by Hondo - Nov 12, 2021, 03:32
Doing an engine swap and trying to locate the pin layout for identifying which pin is what. Have the part number and V.I.N. for both vehicle. One is a 2011 Ford F250 and other is a 2017 Ford F450. Do not want to cut and solder but swap the plug if possible. If anyone knows where I could locate the layouts for both , it would be much appreciated.
Thank you in advance.
15
Interfaces, Pinouts, Cables / Hard wire unit
Last post by jmv - Oct 28, 2021, 03:41
I want to hard wire this unit into my camper.  Does anyone have a diagram showing the pin nomenclature & color codes?
16
Interfaces, Pinouts, Cables / No sound
Last post by Rob1944 - Sep 23, 2021, 17:31
Hi plugged in a after market sterio in 2004 Lexus rx300 sterio comes on fine but no sound any ideas please

Bob
18
Ищу распиновку кабеля для прошивки КВМ ATEN LIN5-04A2-J13G - стерео jack на com портYou cannot see attachments on this board.
19
Hello There,

Anyone here is aware how to interface the mPCIe signals to M.2 adaptor for NVME SSD drives?
20
Anyone have a source for a 32 pin harness for connecting to the wiring that goes into the Bluetooth Handsfree unit? This is in a 2014 EX without navigation, with i-Mid.

I want to replace the factory radio without cutting into any of the existing wiring. The Axxess HDCC-01/ASWC-1 combo comes with a harness for all the other connectors, but not that one. I want to use the phone controls, and maybe the built in mic that are in that connector.
Pages 1 2 3 4 ... 10