Recent posts

May be this one ?

Please photo rear side of your head unit
This is a photo of the adapter for hyundai mobis tq8-acb10d3gg used in Tucson 2019. I need a pinout diagram for the head unit rear connector. Thank you.
Need pinout for Hyundai/Mobis TQ8-ACB10D3GG head unit. Changed my head unit but lost the connectors for my old one . Model is for Hyundai Tucson 2019. Thank you.
Errors and updates / Re: Calcomp model 34480 with 1...
Last post by BranCro - Aug 19, 2019, 20:55
Dear LordZedd,
i also have a problem with the same cable. I found that pin 21> 4 does not work. I have no knowledge to repair the same, and I cannot find the place of purchase on the internet. Do you know where to buy?
I used some headphones/earbuds that audio exits from 1 and 3.

I have done some tries with a vip5602EW/vip5662EW. All arris boxes seem to use the same breakout/breakaway cable.

With a multimeter I have found that the ground pins are 2,4,7 and 9.  Which means all the others are the analog component, composite, and stereo audio outputs
I lost the subpack for the Iaudio (Cowon) X5, I bought the charging/sync cable,
but it doesn't have the Line-In/Line-Out that is on the Subpack, so I would like a pinout
for the connector on the bottom of the X5 (that the Subpack connects to).

I also have a Iaudio (Cowon) D2 and I was wondering what the little connector they use
you have the pinout on here but I dont know what kind of connector it is or where to get one.
Hello there I'm engineering electronic and work for a company who fix verifone terminal POS.

I'm looking this kind of pinout Ethernet Pulse Jack j3011g21d.

This connector internal has some coil, resistors.

If someone can help please I've been so graceful and share some of my technics to fix electronics equipment
I have an old IDE drive I'm trying to extract files from. Please see photo. Is the smaller pin intentionally NULL or is it pushed down by design? Can you find a pinout of the model so I can see or is there another way to test it? Thank you.[/img]
Hi all,

I have the same printer as listed in this pinout:

I had to purchase a custom power supply so I've purchased this one:

Note it has a simple positive and negative adapter on the end.

Based on the pinout link above, what pins should I be connecting the power supply's two pins?

Thanks so much